Navigation
	Cable kits for Winpilots
	PDA mountings
	PDA accessories
	Second hand PDA
	Bug wipers

Cable kit: PRO


Filser LX160Si variometer connected to Volkslogger and Winpilot Pro	Pro connection box

Pro kit is specially made to connect the Winpilot compatible variometer to PDA-logger-Winpilot Pro combination.

Winpilot Pro software works as Adv but is prepared to get following additional data from the variometer
            - vario data
            - airspeed EAS
            - ballast data
            - bug data
            - MC-data
In addition the position, altitude and airspeed (TAS) are coming with the NMEA data from the logger as normal.

With this data is the software capable to calculate and show all needed to make Winpilot Pro to perfect gliding computer. As good as the old and wellknown Peschges, Zander and Filser flight computers, but with much cheaper.

The clear advantage is the way you can show things in the large graphic PDA display compared to normally rather limited displays used in the flight computers.

The variometer must be compatible with Winpilot to add previous data to the the NMEA GPS sentences sent by the logger through the variometer. The variometer output must be fast and well compensated.
Both LX160Si and B50 has proven to be as good as the old famous ones. The modern microchips and pressure sensor technics has made this possible.

The red button shown in demo unit is to start the PC connection of the Logger. The dataflow control switch ontop overrides the variometer when declaring the task from Winpilot to logger. (Volkslogger or Colibri).

Pro connection kit include "plug and play" cables to connect PDA, Logger and Variometer. The connection box is powering both PDA and the logger through these cables.

Technical data

    - 12-40V power input
    - power consumption at 12V typically 350mA (max 650mA) (iPAQ and GPS)
    - uses effective DC/DC switching mode regulator with efficient RF noice damping for 5V
       output
    - guarded against reverse polarity.
    - 1A internal fuse
    - continuous power supply during battery change for GPS.

There are available also special kits for two-seater with 2A output and double PDA cables

Pro kit fits to following variometers

        Filser LX160
        Borgelt B50
        Filser LX5000
        Westerboer VW921/922

PDA´s supported

        Compaq iPAQ 31/36/37xx
        Compaq iPAQ 38/39xx
        HP iPAQ 54/55xx
        HP iPAQ 4150 and 2210
        HP iPAQ 1710, RX3175, HX4700 and H6340
        Dell Axim X3 and X5
        ASUS
        PALM
        Toshiba
        CASIO
        HP Jornada
        Fujitsu Pocket Loox

Loggers supported

        Volkslogger old (5-pin round)
        Volkslogger new RJ45 (square)
        Colibri and LX20
        Gambridge
        Peschges VP8